Press "Enter" to skip to content

Knowledge Base

 

How to switch off “failed to write JUMBO frame” warnings

This article shows how to get rid of the “failed to write JUMBO frame” warnings an Linux by disabling various offloading settings.

Setup and Test of the BalanceNG SNMPD interface

This article shows how to setup and test SNMPD in conjunction with BalanceNG.

How to enable the loopback adapter on Windows 2008

This article shows how to enable the loopback adapter on Windows 2008 using netsh.

Important VMware Settings for BalanceNG

When BalanceNG is run inside a VMware virtual machine, the VM needs a few extra permissions and settings. This article references all the necessary information.

How to setup wget as an external HTTP health check

Calling wget as an HTTP health check has many advantages. This article shows how to configure that.

How to specifically route back server traffic to the Load Balancer (source routing)

How to setup the loopback alias for DSR on Windows

How to make the loopback alias permanent in Solaris 10

How to deal with ARP-Problems on Linux

How to identify physical ports with ethtool on Linux

Installing BalanceNG from the Thomas-Krenn.AG Debian Repository

General BalanceNG upgrade procedure for a dual node HA setup

How to enable SNMP on Windows for CPU-load monitoring with ascript and snmpload.sh

How to strip the FCS (Frame Check Sequence) on Solaris e1000g interfaces

Using 802.1q VLANs on Linux

BalanceNG Benchmark Results